It seems that most of the drywall mounts that I looked for printed in a vertical orientation, which is not good for strength.

For once, I didn’t reverse engineer anything to design this. Lulz.

https://www.printables.com/model/548516-printable-drywall-mount


Update 8/10 - Added dimension sketches, Added .step file, Added a thinner support ring option that will sit more flush (but not completely)

  • Imgonnatrythis@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    I don’t say no to hugs.

    That retainer ring looks pretty stout. Do you somehow counter-sink that to get it flush or just let that hang out?

    • remotelove@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      They sit 3mm proud. This is not an issue if they are hidden, me thinks. However, you should be able to not use the support ring if it is an issue. (I’ll modify a design today in attempt to reduce the amount it sticks out.)

      Also, these are intended to be extremely secure and almost permanent. If you want it flush, you can probably pound it in a little more with a hammer. If not, leave it proud and it gives you a little meat to pull it out of the wall later.