Manufacturers say that installing a couple of 300-watt panels will give a saving of up to 30% on a typical household’s electricity bill. With an outlay of €400-800 and with no installation cost, the panels could pay for themselves within six years.

In Spain, where two thirds of the population live in apartments and installing panels on the roof requires the consent of a majority of the building’s residents, this DIY technology has obvious advantages.

With solar balconies, no such consent is required unless the facade is listed as of historic interest or there is a specific prohibition from the residents’ association or the local authority. Furthermore, as long as the installation does not exceed 800 watts it doesn’t require certification, which can cost from €100 to €400, depending on the area.


As with all solar power systems, balcony power only works in daylight and a battery storage system can add at least €1,000 to the installation cost.


Vernetta says the vertical surface area of cities is far greater than that of the roofs and that, in Spain, balcony panels benefit more than roof panels from the low winter sun.

Cities such as Helsinki are already experimenting with buildings with solar panel cladding.

  • jagged_circle@feddit.nl
    link
    fedilink
    English
    arrow-up
    1
    ·
    edit-2
    11 hours ago

    I dont understand. These people can just install more switches to solve this problem, right?

    We were just dumb before and thought power was unidirectional. Now we have evolved into a decentralized grid. So we just need to add another switch to cut off power coming out of every room, building, etc. Right?

    That seems like the obvious long-term, safest solution.

    • ne0phyte@feddit.org
      link
      fedilink
      arrow-up
      2
      ·
      edit-2
      3 hours ago

      We have regulations here in Germany (EU wide even if I am not mistaken). The solar inverters used are required to shut off within I think 200ms of the 50hz grid power going down. The inverters sold here can’t output anything without grid power being detected on the AC output.

      Why is everyone in this thread making assumptions and spreading fear instead of actually looking up how it works?