Anyone know what settings to change in Cura to help supports leave less markings on the print body?

  • CmdrShepard@lemmy.one
    link
    fedilink
    arrow-up
    1
    ·
    1 year ago

    I think splitting the model down the center will give the best results, but you could also try doing a shorter layer height. Your slicer will leave a gap between the top of the support and the bottom of the print equivalent to at least one layer, so with 0.2mm layers you get at least 0.2mm of sag. With thinner layers, this gap is thinner and allows for less sagging in the print.