[OpenFFBoard] [ODrive] First test of my openffboard build with power
vimeo.com
A quick test, without a wheel attached to the spindle, of the openffboard, running on Linux, in BeamNG.drive. It took a while to get here as I'm not very knowledgeable…

cross-posted from: https://infosec.pub/post/4625991

A quick test, without a wheel attached to the spindle, of the openffboard running on Linux in BeamNG.drive. It took a while to get here as I’m not very knowledgeable with motor drivers but it seems to work so far.

Next step will be to fabricate a bracket to mount it to my rig. Since this video I have mounted a wheel and done some driving. The feel is pretty good, the motor is only 6NM which in DD land is a little on the low side but it’s incredibly smooth.

Hardware:

OpenFFBoard (purchased assembled)

ODrive S1

Baldor BSM90N-1150AFP (ebay auction for untested motor, was about 50USD shipped)

48v 10.5A power supply

  • mranderson17@infosec.pubOPEnglish
    2·
    1 year ago

    Nice! I wish I had the space for a motion rig. That sounds like a fun project.

    What motors are you looking at?

      • mranderson17@infosec.pubOPEnglish
        0·
        1 year ago

        LOL, that’s amazing. I have one of those chairs which is currently piled with extra blankets and no one has sat in it in years. I may have to give that “1 DOF of relaxing movement” a try too! Even if I have to drag it out of the way when not in use. That’s a much smaller footprint than what I was imagining for a motion rig.